Installing The Battery Pack - Toro Greensmaster eFlex 2120 Series Operator's Manual

4
Installing the Handle
Retainers
Parts needed for this procedure:
2 Handle retainer
2 Hairpin cotter
Procedure
1. While supporting the handle, remove the cable
ties that secure the handle clamps to the side
plates (Figure 9).
1. Hairpin cotter
2. Pivot the handle to the desired operating position
and insert a handle retainer over the handle
clamp and into the matching holes in the side
plate (Figure 9).
3. Secure the clamp in position with a hairpin cotter
(Figure 9).
4. Repeat the procedure on the opposite side of
the handle.
5. Adjust the handle height to the desired position;
refer to Adjusting the Handle Height (page
Note:
The machine is shipped with the handle
adjusted to the lowest position. The machine is
traditionally operated with the handle telescoped
out to its maximum height.
Figure 9
2. Handle retainer
5

Installing the Battery Pack

Parts needed for this procedure:
1 Battery pack
6 Bolt (5/16 x 1/2 inch)
6 Washer
Procedure
1. Remove the battery pack from its carton.
Save the carton and all packing materials. If
you need to ship the battery for maintenance,
warranty, or recycling, you will need this
special packaging.
Refer to the Installation Instructions
included with the Battery Shipping Kit (the
instructions can be found at www.Toro.com).
2. Cut the cable tie that secures the battery charger
to the battery base on the machine and remove
the charger.
3. Disconnect the small connector on the pack to
the machine wire harness from the main wire
harness
g017355
23).
1. Connector—main wire
harness
4. Remove the tall nut that secures the rear of the
battery base to the machine frame
11
(Figure 10).
Figure 10
2. Small connector—battery
pack
g234802
(Figure 11).