Replacing Fuses - Toro Greensmaster e1021 Operator's Manual

Maintaining the Battery-Charger
Cords
•
Clean the cords with a slightly damp cloth after
each use.
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and
replace them when necessary with Toro-approved
parts.
Cleaning the Battery-Charger Case
Clean the case with a slightly damp cloth after each
use.

Replacing Fuses

If the machine does not turn on, even after charging,
check the machine fuses as follows:
1. Turn off the machine and disconnect the battery
pack.
2. Remove the 4 screws
the battery-pack cover and remove the cover.
Figure 26
1. Screws
3. Check the fuses in the fuse block
(Figure 26) that secure
g341636
2. Fuse block
(Figure 27).
1. 30A—main power supply
circuits
2. 3A—logic power supply
circuits
4. If any fuse is blown, replace them with a fuse of
the appropriate voltage and amperage
27). Refer to the traction unit Service Manual for
specific fuse part numbers.
Important:
All fuses on the machine are
rated for 80 V. Do not use 12 V automotive
fuses.
29
Figure 27
3. 3A—optional LED work
light circuit
4. Open slot
g300604
(Figure