Accessing The Transmission Cover Hole; Engaging/Disengaging The Transmission-Belt Tensioner - Toro Greensmaster eFlex 2120 Series Operator's Manual

B. Using a 16 mm (5/8 inch) wrench, rotate the
bearing housing to ensure that it operates
freely.
C. Clean any debris from inside the belt
compartment and from around the
compression spring
D. Ensure that the compression spring is
applying the proper tension on the belt.
E. Tighten the bearing housing mounting nut.
F. Install the belt cover.
Accessing the
Transmission Cover Hole
Remove the rubber plug
the front of the transmission if you need to access the
reel clutch.
Important:
Do not operate the machine without
the rubber plug.
Figure 49
1. Engage/disengage shaft
(Figure 48).
(Figure 49) from the hole in
2. Rubber hole plug
Engaging/Disengaging
the Transmission-Belt
Tensioner
The transmission belt is tensioned by a spring-loaded
idler pulley. If you must engage or disengage the
belt tension, use a 3/8-inch wrench to rotate the
engage/disengage shaft
position. Rotating the shaft 1/4 turn (90°) clockwise
disengages the idler from the belt
Note:
You must disengage the belt tension before
removing the transmission cover.
Note:
The transmission belt is properly tensioned
when the alignment marks on the transmission cover
and the engagement shaft are aligned.
1. E
NGAGED
g017387
39
(Figure 49) to the desired
(Figure 50).
Figure 50
2. D
ISENGAGED
g019886