Installing The Cutting Unit To The Traction Unit - Toro Greensmaster Flex 1800 04040 Operator's Manual

Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Cutting Unit to
the Traction Unit
Parts needed for this procedure:
2 Bolt, 3/8 x 3/4 inch
Procedure
1. Place the mower on its drums on a level surface.
2. Lower the kick stand and push in the locking pin to
lock the kick stand in the service position
Allow the machine to rest on the locking pin.
1
2
3
1. Kickstand—storage
position
2. Locking pin
3. Push the cutting unit under the traction unit and to the
left to engage the transmission coupling
(Figure
Figure 3
3. Kickstand—service
position
(Figure
1. Transmission coupling
4. Maneuver the traction unit frame
until it engages the cutting unit pivot arms.
3
3).
2
1
G017242
1. Cutting unit pivot arms
2. Traction unit frame
G018142
5. Secure the traction unit frame to the cutting unit pivot
arms with 2 bolts (3/8 x 3/4 inch)
Note: To remove the cutting unit, just loosen the 2
bolts (3/8 x 3/4 inch) approximately 1–1/2 turns and
rotate the pivot arms out.
6. Push down on the kick stand to release the spring
loaded locking pin and allow the kick stand to rotate
4).
up to the storage position.
10
Figure 4
(Figure 5) forward
Figure 5
3. Bolts
(Figure 5).