1
1. Flange-head bolt
3
Preparing the Traction Unit
For cutting unit 04251, 02452, 04253, or
04254
No Parts Required
Procedure
If you are installing cutting unit 04251, 02452, 04253, or
04254 on this traction unit, complete the following steps:
1. Position the cutting unit on a flat, level surface.
2. On both pitch arms
inch) in on the tabs and grind down the corner as
shown in
Figure
7.
1. Pitch arms
2
G026124
Figure 5
2. Weight rod
(Figure
6), measure 2.3 mm (0.09
Figure 6
3. Paint the revealed metal to prevent corrosion.
g026124
4
Installing the Cutting Unit to
the Traction Unit
Parts needed for this procedure:
2
Bolt (3/8 x 3/4 inch)
Procedure
Note: To install the weight rod onto your machine, refer to
the installation instructions in your Cutting Unit Operator's
Manual.
1. Place the mower on its drums on a level surface.
2. Lower the kick stand and push in the locking pin to
lock the kick stand in the service position
Note: Allow the machine to rest on the locked
kickstand.
Note: Place the kickstand in this position whenever
you remove the reel. This will keep the machine from
tipping backward onto the handle.
g034505
11
Figure 7
(Figure
g034506
8).