Suzuki DL1000 Service Manual page 358

GEAR POSITION SWITCH
• Remove the seat. (!6-4)
• Remove the fuel tank front cover.
• Remove the fuel tank side covers.
• Lift and support the fuel tank with the fuel tank prop stay.
(!4-51)
• Disconnect the gear position swtich coupler and check the
continuity between Blue and Black with the transmission in
"NEUTRAL".
ON (Neutral)
OFF (Expect neutral)
"
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch to "ON" position and side-stand to
upright position.
Measure the voltage between Pink and Black lead wires using
the multi circuit tester when shifting the gearshift lever from low
to top.
# 09900-25008: Multi circuit tester set
' Tester knob indication: Voltage (&
$ Gear position switch voltage: More than 0.6V
( * Low to top gear position
* Except neutral position
NOTE:
* When connecting the multi circuit tester, use a fine copper wire
(O.D is below 0.5 mm) to the back side of the lead wire coupler
and connect the probes of tester to them.
* Use a fine copper wire, the outer diameter being below 0.5
mm, to prevent the rubber of the water proof coupler from
damage.
TURN SIGNAL/SIDE-STAND RELAY
The turn signal/side-stand relay is composed of the turn signal
relay, and the side-stand relay and diode.
• Remove the seat. (!6-4)
• Remove the turn signal/side-stand relay.
Blue Black
& ) & &
(Pink – Black)
ELECTRICAL SYSTEM 7-15