Brake Fluid Replacement - Suzuki DL1000 Service Manual

6-68 CHASSIS
NOTE:
Make sure that the detent of the pad is seated onto the retainer
on the caliper bracket.
• Tighten the caliper mounting bolt 7 and pad mounting pin 8
to the specified torque.
& Rear brake caliper mounting bolt:
Rear brake pad mounting pin:
• Install the plug 9 to the specified torque.
& Pad pin plug: 2.5 N·m (0.25 kgf-m, 1.8 lb-ft)
NOTE:
After replacing the brake pads, pump the brake pedal several
times in order to operate the brake correctly and then check the
brake fluid level.

BRAKE FLUID REPLACEMENT

• Remove the right frame cover. (!6-5)
• Remove the brake fluid reservoir cap.
• Replace the brake fluid in the same manner as the front
brake. (!6-58)
, Specification and Classification: DOT 4
"
Bleed air from the brake system. (!2-24)
23 N·m (2.3 kgf-m, 16.5 lb-ft)
17 N·m (17 kgf-m, 12.5 lb-ft)