Suzuki DL1000 Service Manual page 132

3-86 ENGINE
• Install the gear position switch and cable guide.
OIL PUMP DRIVEN GEAR
• Install the washer 1 and pin 2.
• Install the oil pump driven gear by installing the snap ring.
" 09900-06107: Snap ring pliers
NOTE:
The boss A of the oil pump driven gear faces crankcase side.
CLUTCH
• Install the thrust washer onto the countershaft.
NOTE:
The chamfer side A of thrust washer faces crankcase side.
• Install the needle bearing 1 and spacer 2 onto the counter-
shaft.
• Apply engine oil to them.