Suzuki DL1000 Service Manual page 154

3-108 ENGINE
NO.2 (REAR) CAMSHAFTS
• Install the No.2 (Rear) camshafts, intake and exhaust, in the
following procedure.
• From the position where the No.1 (Front) camshafts have now
been installed, rotate the generator rotor 360 degrees (1 turn)
and align the "F I T" line on the generator rotor with the index
mark of the valve timing inspection hole.
NOTE:
At this position, the engraved line A on the cam drive idle gear/
sprocket is inside the cylinder head and not visible.
• Place the No.2 (Rear) camshafts, intake 1 and exhaust 2.
• Align the engraved lines B on the camshafts so that it is par-
allel with mating surface of the cylinder head cover. Check
that the cam faces are located as shown.
• Install the dowel pins.
No. 2 (Rear) cylinder head
"E"
"I"