Suzuki DL1000 Service Manual page 140

3-94 ENGINE
OIL JET
• Apply engine oil to the new O-rings.
• Install each of the oil jets.
#
Use the new O-rings to prevent oil leakage.
CYLINDER
• Coat SUZUKI BOND "1215" lightly to the mating surfaces at
the parting line between the right and left crankcases as
shown.
NOTE:
When replacing the stud bolt A, apply SUZUKI BOND "1215" to
the thread of the crankcase side.
+ 99000-31110: SUZUKI BOND ''1215''
• Fit the dowel pins and new gaskets 1 to the crankcase.
#
Use the new gaskets to prevent oil leakage.
• Apply engine oil to the sliding surface of the pistons and cylin-
ders.
NOTE:
The cylinders can be distinguished by the embossed-letters, "F"
and "R".
"F": Front (No.1) cylinder
"R": Rear (No.2) cylinder
FRONT
"R"
"L"