Suzuki DL1000 Service Manual page 120

3-74 ENGINE
• Tighten the special tool bolt to the specified torque.
$ Special tool bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
#
Before installing the bearings, lightly shave off the
sharp edge part of the crankcase chamfer by using an
oilstone and wash the crankcase bore with enough
engine oil.
• Set the bearings installed in the special tool to the crankcase
half as shown.
#
* Be sure the bearing protruded side A faces the
crankcase bore.
* Align the special tool mating surface with the line
mark B on the crankcase.
NOTE:
The upper and lower bearings are same.
Snarp edge