Suzuki DL1000 Service Manual page 225

4-66 FI SYSTEM
• Apply thread lock "1342" to the actuator cover nuts and
tighten them.
( 99000-32050: THREAD LOCK "1342"
' STVA cover nut: 2.0 N·m (0.2 kgf-m, 1.5 lb-ft)
• Install the fast idle cam and tighten its mounting nut.
' ' Fast idle cam mounting nut: 4.0 N·m (0.4 kgf-m, 3.0 lb-ft) ' '
• Tighten the throttle body link plate bolts securely.
' ' Throttle body link plate bolt: 5 N·m (0.5 kgf-m, 3.7 lb-ft) ' '
• Position the TV control lever between the TV synchronizing
screw A and spring as shown.
• Set each TV to the same opening by turning the synchroniz-
ing screw A.
• Position the STV control lever between the STV balance
screw B and spring as shown.
NOTE:
Apply grease to the screw end and spring if necessary.
• Apply thin coat of the engine oil to the new fuel injector cush-
ion seals 1, and install them to each fuel injector.
"
Replace the cushion seal with a new one.
• Install the seal 2 and O-ring 3 to each fuel injector.
• Apply thin coat of the engine oil to the new O-rings 3.
• Install the fuel injectors by pushing them straight to each throt-
tle body.
"
Replace the dust seal and O-ring with the new ones.
Never turn the injector while pushing it.