Table of Contents
Advertisement
6. Verify that the cooling module LED light is green.
Note:
The LED goes from yellow to green. It can take up to 1 minute for the LED to turn green.
Removing the cooling module from the VSP 9010
Remove the cooling module from the slot at the front of the chassis to replace it. You can hot swap
the cooling modules.
Before you begin
• Remove the air inlet bezel.
• Acquire the following items:
- Phillips #2 screwdriver
- Antistatic wrist strap
Electrostatic alert:
ESD can damage electronic circuits. Do not touch electronic hardware unless you wear a
grounding wrist strap or other static-dissipating device.
Procedure
1. Loosen the captive screws that secure the cooling module to the midplane.
2. Press the cooling module service button and hold for 3 seconds or until the LED flashes red.
The fans begin to spin down.
Important:
The fans do not spin down completely at this point due to the spinning fans of the
companion cooling module. You have 15 seconds to remove the cooling module before
the fans begin to spin back up. The LED flashes faster when only 5 seconds remains.
March 2015
Removing the cooling module from the VSP 9010
Installing Cooling Modules in Avaya VSP 9000
Comments? infodev@avaya.com
49
Advertisement
Table of Contents
