Table of Contents
Advertisement
Figure 15: I/O cooling module partially removed
Note:
When using the 9048XS-2 I/O module, both fan tray bays must be installed with
9012FCHS cooling modules.
3. With one hand, pull the pin on the cooling module to the right, and then hold it in place.
4. Slide the cooling module into the chassis until the cooling module is flush with the chassis
side.
The connector at the rear of the cooling module must connect to the midplane.
5. Release the pin on the cooling module.
6. Verify that the cooling module LED light is green.
March 2015
Installing the I/O cooling module for the VSP 9012
Installing Cooling Modules in Avaya VSP 9000
Comments? infodev@avaya.com
53
Advertisement
Table of Contents
