Installing The Sf Cooling Module For The Vsp 9012 - Avaya 9012FC IO Manual

Figure 16: I/O cooling module partially removed
3. Continue to slide the module out of the chassis and use your free hand to support the weight
at the rear of the module.

Installing the SF cooling module for the VSP 9012

Install the SF cooling module in the back of the chassis to provide cooling to the SF modules. You
must install two SF cooling modules in the chassis. You can hot swap the cooling modules.
Procedure
1. Locate the bay where you want to install the cooling module.
2. Grasp the handle on the cooling module and slide the module into the chassis until the
module is flush with the side of the chassis.
The connector at the rear of the cooling module must connect to the midplane.
March 2015
Installing the SF cooling module for the VSP 9012
Installing Cooling Modules in Avaya VSP 9000
Comments? infodev@avaya.com
55