Removing The I/O Cooling Module For The Vsp 9012 - Avaya 9012FC IO Manual

Cooling module installation and removal for the VSP 9012

Removing the I/O cooling module for the VSP 9012

Remove the I/O cooling module from the slot at the front of the chassis to replace it. You can hot
swap the cooling modules.
Before you begin
Acquire the following items:
• Phillips #2 screwdriver
• Antistatic wrist strap
Electrostatic alert:
ESD can damage electronic circuits. Do not touch electronic hardware unless you wear a
grounding wrist strap or other static-dissipating device.
Procedure
1. With one hand, pull the pin on the cooling module to the right and hold it in place.
Danger:
Risk of personal injury
When you remove a cooling module, allow time for the fans to spin down before you fully
withdraw the cooling module. Be careful to keep your fingers out of the fan blades, as
shown in the following figure.
2. Pull the module out of the chassis until it is partially removed, as shown in the following
figure. Allow time for the fans to spin down.
Installing Cooling Modules in Avaya VSP 9000
54
Comments? infodev@avaya.com
March 2015