Motor Bearings - Henny Penny EVOLUTION ELITE Series Operator's Manual

Disconnect power supply before a thorough cleaning or servicing the fryer.
2 2 . . 1 1 0 0 M M o o t t o o r r B B e e a a r r i i n n g g s s
The electric motor bearings are permanently lubricated. DO NOT LUBRICATE.
2 2 . . 1 1 1 1 L L i i g g h h t t i i n n g g & & S S h h u u t t d d o o w w n n O O f f T T h h e e B B u u r r n n e e r r s s
2 2 . . 1 1 1 1 . . 1 1 L L i i g g h h t t i i n n g g O O f f T T h h e e B B u u r r n n e e r r s s
Turn the power switch to the off position.
1 1 ) )
Wait at least 5 minutes and then turn power switch to the on position.
2 2 ) )
Press the heat button
3 3 ) )
The burner lights and operates in a Melt Cycle until the shortening reaches a
4 4 ) )
preset temperature.
Once the display shows a product selection or a double dashes, press the
5 5 ) )
desired product button.
NOTE: The fryer is equipped with a ignition spark module which has a set ignition
safety time (TSA) of 90 seconds.
2 2 . . 1 1 1 1 . . 2 2 S S h h u u t t d d o o w w n n O O f f B B u u r r n n e e r r s s
Press either heat button
1 1 ) )
Turn the power switch to the off position.
2 2 ) )
NOTE: This turns off all vats.
2 2 . . 1 1 2 2 T T e e s s t t i i n n g g T T h h e e F F r r y y e e r r
Each Henny Penny open fryer was completely checked and tested prior to shipment.
However, it is good practice to check the unit for proper operation.
10
on the controls (left or right).
on the controls.