Table 2-7 Checking Procedure - Buzzer Coil; Table 2-8 Checking Procedure - Microswitch; Table 2-9 Checking Procedure - Motor; Table 2-10 Checking Procedure - Reset Coil - Henny Penny 600 Service Manual

T T a a b b l l e e 2 2 - - 7 7 C C h h e e c c k k i i n n g g P P r r o o c c e e d d u u r r e e - - B B u u z z z z e e r r C C o o i i l l
Test Points
S S w w i i t t c c h h i i n n O O F F F F p p o o s s i i t t i i o o n n
Check from #14 to #75
• 120 volt 50/60 Hz
• 208-240 volt 50/60 Hz
T T a a b b l l e e 2 2 - - 8 8 C C h h e e c c k k i i n n g g P P r r o o c c e e d d u u r r e e - - M M i i c c r r o o s s w w i i t t c c h h
Test Points
T T i i m m e e r r S S e e t t A A t t 1 1 0 0 M M i i n n . .
Check from #70 to #72
Check from #70 to #14
T T i i m m e e r r S S e e t t A A t t 0 0 M M i i n n . .
Check from #70 to #72
Check from #70 to #14
Test Points
Check from #70 to #75
120 volt 50/60 Hz
208-240 volt 50/60 Hz
T T a a b b l l e e 2 2 - - 1 1 0 0 C C h h e e c c k k i i n n g g P P r r o o c c e e d d u u r r e e - - R R e e s s e e t t C C o o i i l l
Test Points
Check from #70 to #75
120 volt 50/60 Hz
208–240 volt 50/60 Hz
2 2 . . 1 1 6 6 . . 3 3 R R e e p p l l a a c c e e m m e e n n t t
Remove control panel per
1 1 ) )
Label the wires and remove them from the timer.
2 2 ) )
Remove four screws securing the timer to the control panel.
3 3 ) )
NOTICE:
Results
1550 ohms
5880 ohms
Results
Closed circuit
Open circuit
Open circuit
Closed circuit
T T a a b b l l e e 2 2 - - 9 9 C C h h e e c c k k i i n n g g P P r r o o c c e e d d u u r r e e - - M M o o t t o o r r
Results
290 ohms
3990 ohms
Results
280 ohms
3950 ohms
2.4 Lower the Control , page
Replacement of timer may not be necessary if lamp is
burned out, if buzzer coil is burned open, or if ON/OFF
switch is bad, timer motor and timer microswitch can be
replaced separately.
14.
43