Henny Penny EVOLUTION ELITE Series Operator's Manual page 91

Display Cause
"E-60" AIF PC board not
"FILTER IN communicating
USE" with PC board.
"E-70C" Drain valve jump-
er wire missing or
disconnected.
"E-83-A" Pressure too
high.
"E-83-B" Pressure too
high.
"E-83-C" Pressure too high
"E-83-D" Pressure too
high.
"E-83-E" Pressure too
high.
"E-83-J" Bulk BIB FILL
switch ON when
pressure too
high.
"E-83-R" Bulk Dispose
switch ON when
pressure too
high.
"E-931" Autolift motor
"24 VDC malfunction or
SUPPLY failure.
TRIPPED"
Panel Board Correction
Turn power switch to OFF, wait 15 seconds, then turn
switch back to ON. If "E-60 persists, have connector be-
tween the PC boards checked; replace AIF PC board or
control PC board if necessary.
Have the jumper wire checked on the PC board at drain
switch interlock position.
Check filter system in Vat #1.
Check filter system in Vat #2.
Check filter system in Vat #3.
Check filter system in Vat #4
Check filter system in Vat #5.
Check BIB fill valves.
Check Bulk Dispose quick-disconnect behind fryer.
If AutoLift feature is not operating, have each of the Auto-
lift motors checked.
81