Henny Penny EVOLUTION ELITE Series Operator's Manual page 88

Problem
Oil will not
drain from
vat.
Filter motor
runs but
pumps oil
slowly.
Bubbles in
oil during
entire filter-
ing
process.
Filter motor
will not run.
78
Cause
Drain valve clogged Open valve, force cleaning brush through drain. Re-
with crumbs. move the cleaning brush immediately so the drain valve
does not close on the brush, which can damage the
brush and drain valve. Skim vat more often to prevent
clogs.
Drain trough Remove right side panel and remove plug from end of
clogged. trough, clean trough.
Filter line connec- Tighten all filter line connections.
tions loose.
Filter paper or pad Change filter paper or pad.
clogged.
Filter not reas- Refer to assembly instructions on inside door.
sembled properly.
Filter pan not com- Make sure filter pan return line is pushed completely in-
pletely engaged. to the receiver on the fryer.
Filter pan clogged. Clean pan and change paper or pad.
Damaged O-ring on Replace O-ring.
filter line receiver
on fryer.
Thermal reset but- Allow motor to cool, then, using a screwdriver, press
ton on the rear of hard against the button until it clicks.
the pump motor is
tripped.
T T U U R R N N O O F F F F P P O O W W E E R R
• T T o o a a v v o o i i d d b b u u r r n n s s c c a a u u s s e e d d b b y y s s p p l l a a s s h h i i n n g g s s h h o o r r t t e e n n i i n n g g , ,
t t u u r r n n t t h h e e u u n n i i t t ' ' s s p p o o w w e e r r s s w w i i t t c c h h t t o o t t h h e e O O F F F F p p o o s s i i t t i i o o n n
b b e e f f o o r r e e r r e e s s e e t t t t i i n n g g t t h h e e f f i i l l t t e e r r p p u u m m p p m m o o t t o o r r ' ' s s m m a a n n u u a a l l
r r e e s s e e t t p p r r o o t t e e c c t t i i o o n n d d e e v v i i c c e e . .
Correction