Aligning The Needle Bar Linkage Sideways - DURKOPP ADLER D867 M-Type Delta Service Instructions Manual

Adjusting feed dog and needle bar linkage
10. Tighten the threaded pins (1).
11. Finish the service routine.

7.3 Aligning the needle bar linkage sideways

Fig. 33: Aligning the needle bar linkage sideways (1)
(1) - Screws
(2) - Set collars
(3) - Screw
Proper setting
If the stitch length is 0, the needle pierces exactly in the center of the
needle hole.
To align the needle bar linkage sideways:
1. Switch off the machine.
2. Disassemble the front cover ( p. 20).
3. Disassemble the head cover ( p. 21).
4. Switch on the machine.
5. Execute the service routine Needle-Hook > Needle bar ( p. 14).
 The software is used to define the necessary presettings on the
6. Loosen the threaded pins (1) on the set collars (2).
7. Loosen the screw (3).
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
In the process, make sure that the feed dog height has the correct
setting ( p. 51).
①
② ③
machine.
(4) - Needle hole
(5) - Needle bar linkage
⑤
④
47