DURKOPP ADLER D867 M-Type Delta Service Instructions Manual page 153

Programming
Each input can be switched to Latching or Hold to run.
Output Configuration
Configure and allocate the outputs here. The table shows the outputs and
their allocation. The pins on the PCB are labeled and must be allocated
according to the table, depending on what was connected to the pin.
Each output can be assigned one of the following modes.
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
nd
• 2 edge guide position (gap and height)
• DB3000
• DB2000
• Function module 1
• Function module 2
• Function module 3
• Function module 4
• Function module 5
• Function module 6
• Function module 7
• Function module 8
• Sewing light
• Machine head lighting
• Sewing foot lift
nd
• 2 position sewing foot lift
• Sewing foot lift
• Needle thread tension
• Thread trimmer
• Needle cooling
• NSB knife
• NSB block
• Pos. 1
• Pos. 2
• Clean remaining thread monitor
• Bartack suppression LED
nd
• 2 stitch length LED
nd
• 2 needle thread tension LED
nd
• 2 sewing foot stroke LED
• Center guide LED
• Raise/lower center guide
• Motor running
151