Adjusting the mechanical stitch adjustment
6
6.1 Presetting the stitch regulator gear mechanically
Proper setting
The stitch regulator gear is set to 0.
When the control cam is locked in place, the plates (1) are parallel.
The stitch length is controlled by a stepper motor. The exact zero stitch (stitch
length 0 = no feed) is calculated by the Calibration zero stitch ( p. 175).
Cover
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
Adjusting the mechanical stitch adjustment
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you set the
mechanical stitch adjustment.
There must be no lateral play at the stitch regulator gear.
• Remove the toothed belt cover ( p. 23)
• Motor cover ( p. 22)
• Remove the front cover ( p. 20)
41