Setting The Sewing Foot Stroke Parameters - DURKOPP ADLER D867 M-Type Delta Service Instructions Manual

Icon

19.4.7 Setting the Sewing foot stroke parameters

Various settings can be made for the sewing foot stroke. The possibilities
are explained in more detail in the table.
Icon
134
Menu items
nd
2 needle thread tension
NOTICE
Property damage may occur!
In the case of an excessive sewing foot stroke, the machine may be
damaged and, thus, produce unsatisfactory sewing results.
If the machine is at the second sewing foot stroke height, do not
allow it to sew at an excessive speed.
Menu items
Additional thread tension
nd
If the 2 sewing foot stroke is switched on,
nd
the 2 needle thread tension is
automatically activated (except in the case of
material thickness detection).
Number of stitches 2. stroke off
Number of stitches after which the second
sewing foot stroke is automatically
deactivated.
Automatic
Value range
State After Thread
Trimming
• Value range
unchanged, off, on
State After Power
On
• Value range
unchanged, off, on
Value range
• Value range
On/Off
• Value range
000 - 255
Speed level
Speed up to which the
second sewing foot
stroke is automatically
activated.
• Value range
0000 - 4000 [rpm],
depending on
subclass
Service Instructions M-TYPE DELTA - 00.0 - 12/2019
Programming