Performing Diagnostics - Honeywell AlarmNet 7810iR-ent Installation And Setup Manual

7810iR-ent Internet/Intranet Alarm Receiver Installation and Setup Guide
Action
2. Press the Diagnostics button on the
Advanced Setup Screen. The "Diagnostics"
screen is displayed.
(For AlarmNet Only.)
NOTE: 7810iR-ent Diagnostics cannot be run
using Remote Access feature and will not run
locally if a Remote Access session is active.
The following error message will be displayed
if any diagnostic test is started while a Remote
Access session is active:

Performing Diagnostics

Select any diagnostic test or calibration procedure from the Diagnostics screen by pressing
its associated Test or Calibrate button.
All or any individual test may be run when you access the Diagnostics/Tests screen; however,
each test must be performed one at a time.
At any time when a test is not being performed, you can press:
•
return to the previous screen, or
•
to return to your home page.
7-2
the back button icon at the upper-right corner of the Diagnostics/Tests screen to
the home button icon in the upper left-hand corner of the Diagnostics/Tests screen
Once the Diagnostics screen is exited, subsequent entry to this screen displays
all test options as "Not Performed."
Screen Display