Table of Contents
Advertisement
7810iR-ent Internet/Intranet Alarm Receiver Installation and Setup Guide
Status Channel = 9 (Installer generated test message)
Message
cccc 5555 5555 9
Contact ID Format
Contact ID reporting takes the following format:
Where:
CCCC = customer (subscriber account number)
Q = event qualifier, E = new event, R = restore
EEE = event code
GG = partition number, 00-08 (always 00 for non-partitioned panels)
ZZZ = zone ID number reporting the alarm (001-099), or user number for open/close reports.
* System status messages (i.e. AC Loss, Low Battery) contain zeros in the ZZZ location.
SUBSCRIBER ID #
Event Code Classifications
Not all Contact ID codes are provided by each model Control Panel. For complete Contact ID
code information for your system refer to your Control Panel Installation Guide.
Medical
100
101
102
Fire Alarms
110
111
112
6-12
Definition
System Test Message
Manually triggered test from the radio.
Test signal generated by an AlarmNet Network
Technician for a specific subscriber.
24-hour Network Acknowledgement of Subscriber Status
messages.
Note: For older 7620 and 7620ULF radios, Zone alarms
may also be sent at the same time as a test message.
These messages will be in the identical formats to those
alarms shown for Status Channel 5 or 8, except that the
status channel will be a 9.
CCCC Q EEE GG ZZZ
EVENT
QUALIFIER
Event or
XXXX
Restore
E or R
Me dica l
P e nda nt Tra ns mitte r
Fa il to re port in
Fire
S moke w/Ve rifica tion
Combus tion
EVENT CODE*
PARTITION #
000
Eme rg-P e rs ona l Eme rge ncy-#
Eme rg-P e rs ona l Eme rge ncy-#
Eme rg-Fa il to che ck in-#
Fire -Fire Ala rm-#
Fire -Fire Ala rm-#
Fire -Combus tion-#
Applies to
All
ZONE OR
USER #
C000 or U000
00
Hide quick links:
Advertisement
Table of Contents
