7810Ir-Ent Backup Receiver (Enterprise Application); 7810Ir-Ent Features - Honeywell AlarmNet 7810iR-ent Installation And Setup Manual

7810iR-ent Backup Receiver (Enterprise Application)

Backup receiver is supported for Private LAN configuration only. AlarmNet-i configuration
doesn't support backup receiver. The main objective of the backup receiver is to support un-
interrupted alarm reporting when the primary receiver fails. The backup receiver assumes
the responsibility of the primary receiver in case of a primary receiver failure. When a
subscriber detects that the primary receiver is offline or failed, the subscriber directs all
alarms to the backup receiver.
7845i-ent
(Subscriber)

7810iR-ent Features

Automatic rollover to backup CS in the event of automation equipment failure (Future
•
use.)
Touch screen Graphical User Interface (GUI) for ease of use
•
Supports ADEMCO high-speed and ADEMCO Contact ID message formats
•
BlowFish 1024-bit Key message encryption or 256-bit AES
•
Buffers up to 49 messages
•
Selectable supervision period
•
Supports Okidata Microline 320 Serial Printer.
•
Support for uploading/downloading of control panel over IP
•
Three automation modes for received messages:
•
Manual Mode: Stand-alone operation, received messages are displayed on the 7810iR-
ent screen with an audible alert.
LRR Line Card Mode: The 7810iR-ent uses a serial interface to send received alarm
messages to an ADEMCO digital alarm receiver through a long-range radio line card.
685 Automation Mode: The 7810iR-ent emulates the 685 digital receiver output
protocol by using a direct serial interface to send incoming alarm messages to
automation equipment.
Section 1: General Information
7810iR-ent
(Primary Receiver)
7810iR-ent
(Secondary Receiver)
1-3