Firmware Upgrade On The Lte Mini-Physical Interface Module; Mini-Pim Firmware Upgrade Using The Cli - Juniper SRX300 Series Reference Manual

user@host# set interfaces dl0 unit 0 dialer-options always-on
Dial-on-demand mode:
user@host# set interfaces dl0 unit 0 family inet negotiate-address
user@host# set interfaces dl0 unit 0 family inet6 negotiate-address
user@host# set interfaces dl0 unit 0 family inet filter dialer dialer-filter-name
user@host# set interfaces dl0 unit 0 dialer-options pool dialer-pool-number
user@host# set interfaces dl0 unit 0 dialer-options dial-string dial-number
Backup mode:
user@host# set interfaces dl0 unit 0 family inet negotiate-address
user@host# set interfaces dl0 unit 0 family inet6 negotiate-address
user@host# set interfaces dl0 unit 0 dialer-options pool dialer-pool-number
user@host# set interfaces dl0 unit 0 dialer-options dial-string dial-number
user@host# set interfaces interface-name unit 0 backup-options interface dl0.0

Firmware Upgrade on the LTE Mini-Physical Interface Module

IN THIS SECTION

Mini-PIM Firmware Upgrade Using the CLI | 86

Modem Firmware Upgrade Through Over-the-Air (OTA) | 88
Mini-PIM Firmware Upgrade Using the CLI
To upgrade the firmware on the Mini-PIM, using the CLI:
NOTE: When you upgrade the firmware on the Mini-PIM, the modem firmware is also upgraded.
86