1-Port T1/E1 Mini-Physical Interface Module (Srx-Mp-1T1E1-R) Basic Configuration - Juniper SRX300 Series Reference Manual

Table 32: RJ-48 Connector to DB-15 Connector (Crossover) Pinouts (continued)
RJ-48 Pin (on T1/E1 DB-15 Pin (Data Numbering
Mini-PIM) Form)
5 3
3 4
6 2
7 No connect
8 No connect
9 No connect
10 No connect
11 No connect
12 No connect
13 No connect
14 No connect
15 No connect

1-Port T1/E1 Mini-Physical Interface Module (SRX-MP-1T1E1-R) Basic Configuration

IN THIS SECTION
Using the J-Web Interface | 55
Using the CLI | 55
To enable the 1-Port T1/E1 Mini-Physical Interface Module (Mini-PIM) installed on the services gateway,
you must configure the basic settings for the PIM. You can perform the configuration tasks for this using
either the J-Web interface or the CLI.
Signal
TX/Tip/+ <––>RX/Tip/+
Shield/Return/Ground
Shield/Return/Ground
No connect
No connect
No connect
No connect
No connect
No connect
No connect
No connect
No connect
54