8-Port Gigabit Ethernet Sfp Xpim Network Interface Specifications - Juniper SRX300 Series Reference Manual

Table 40: 8-Port Gigabit Ethernet SFP XPIM Supported Modules (continued)
Juniper Product Number
EX-SFP-GE10KT13R15
EX-SFP-GE10KT14R13
EX-SFP-GE10KT15R13
EX-SFP-FE20KT13R15
EX-SFP-FE20KT15R13
EX-SFP-GE40KT13R15
EX-SFP-GE40KT15R13
CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.

8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications

Table 41 on page 67 provides the network interface specifications of the 8-Port Gigabit Ethernet small
form-factor pluggable XPIM (SFP XPIM).
Table 41: 8-Port Gigabit Ethernet SFP XPIM Network Interface Specifications
Network Interface Specification
Operating modes
Connector Type (SFP Transceiver)
1000BASE-BX10, at 10 km (TX 1310 nm / RX 1550
nm)
1000BASE-BX10, at 10 km (TX 1490 nm / RX 1310
nm)
1000BASE-BX10, at 10 km (TX 1550 nm / RX 1310
nm)
100Base-BX Fast Ethernet Optics, at 20 km (TX 1310
nm / RX 1550 nm)
100Base-BX Fast Ethernet Optics, at 20 km (TX 1550
nm / RX 1310 nm)
1000BASE-BX, at 40 km (TX 1310 nm / 1550 nm)
1000BASE-BX, at 40 km (TX1550 nm / RX1310 nm)
If you face a problem running a Juniper Networks device that uses a
Value
Full-duplex and half-duplex
67
Cable
LC
LC
LC
LC
LC
LC
LC