Installing The Wi-Fi Mini-Pim In An Srx Series Services Gateway - Juniper SRX300 Series Reference Manual
High memory gateway interface modules
Hide thumbs
Also See for SRX300 Series:
- Hardware manual (134 pages) ,
- User manual (128 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
SEE ALSO
Installing the Wi-Fi Mini-PIM in an SRX Series Services Gateway
You can install the Mini-PIM in any of the Mini-PIM slots on the services gateway.
NOTE:
You can install only one Wi-Fi Mini-PIM in a services gateway.
To install the Mini-PIM in a services gateway:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the grounding point on the back of the services gateway.
2. Power off the services gateway by briefly pressing the Power button on the front panel. Wait for the
Power LED to turn off before proceeding. Disconnect the services gateway from the power source.
3. Slide the Mini-PIM in the slot until it lodges firmly in the services gateway. Tighten the screws on each
side of the Mini-PIM faceplate. See
Figure 17: Installing the Wi-Fi Mini-PIM
4. Attach the antennas to the front panel of the Mini-PIM. You can attach the antenna by using one of
the following methods:
Direct mounting—Attach the antennas to the RP-SMA connectors on the front panel (see
Figure 13 on page
Figure 17 on page
82).
111.
111
Advertisement
Table of Contents
