1-Port Serial Mini-Physical Interface Module (Srx-Mp-1Serial-R) Overview; 1-Port Serial Mini-Physical Interface Module (Srx-Mp-1Serial-R) Hardware Specifications - Juniper SRX300 Series Reference Manual

1-Port Serial Mini-Physical Interface Module (SRX-MP-1SERIAL-R) Overview

Serial WAN links are bidirectional links and require very few control signals. In a basic serial setup, the
data circuit-terminating equipment (DCE) is responsible for establishing, maintaining, and terminating a
connection. A modem is a typical DCE device. A serial cable connects the DCE to a telephony network
where, ultimately, a link is established with data terminal equipment (DTE). DTE is typically where a link
terminates.
Figure 4 on page 29 shows the front panel of the 1-Port Serial Mini-Physical Interface Module (Mini-PIM).
Figure 4: 1-Port Serial Mini-PIM (SRX-MP-1SERIAL-R) Front Panel
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) provides the following key features:
Autoselection of operational modes based on DTE or DCE cables
Local and remote loopback diagnostics
Configurable clock rate for the transmit (TX) clock and receive (RX) clock
Complete configuration and management by using the CLI and the J-Web interface
The 1-Port Serial Mini-Physical Interface Module (Mini-PIM) supports the following standards:
TIA/EIA 530
V.35
X.21
RS-232
RS-449
1-Port Serial Mini-Physical Interface Module (SRX-MP-1SERIAL-R)
Hardware Specifications
Table 13 on page 30 lists the physical specifications of the 1-Port Serial Mini-Physical Interface Module
(Mini-PIM).
29