Table of Contents
Advertisement
Install an Interface Module
You need the following tools to install the interface module of a CTP151 device:
Phillips screwdriver
ESD wrist strap or other grounding device
To prevent damage from electrostatic discharge, wear an antistatic wrist strap, and ensure proper grounding when handling
components.
To protect the modules, components, and slots when installing components, observe the following guidelines:
CAUTION:
device. This action helps to protect the module from damage by electrostatic discharge.
CAUTION:
connections.
CAUTION:
or other foreign substances and to ensure proper device cooling.
CAUTION:
To install a CTP151 interface module:
1. Wrap and fasten one end of the ESD grounding strap around your wrist and connect the other end to a site ESD point.
2. Choose the slot where you want to insert the module. If only a single module is being installed, it must be installed in
slot 0.
3. With a Phillips screwdriver, loosen the screws that secure the blank filler panel covering the empty chassis slot, if
present, and remove the filler panel.
4. Remove the module from its antistatic bag, being careful not to touch module components, pins, leads, or solder
connections.
5. Guide the module into the chassis by placing it between the guides of the selected slot, and gently push the module
all the way into the slot.
When handling components, use an antistatic wrist strap connected to a proper grounding
Always handle a module by its edges. Do not touch the components, pins, leads, or solder
Be sure to cover every empty slot with a blank filler panel to protect the device from dust
Do not discard the antistatic bag. When a module is not in use, store it in an antistatic bag.
6
Advertisement
Table of Contents
