Cable Specifications And Pinouts; Connector To Rj-48 Connector Pinouts For The 1-Port T1/E1 Mini-Physical Interface Module (Srx-Mp-1T1E1-R) - Juniper SRX300 Series Reference Manual

Cable Specifications and Pinouts

IN THIS SECTION
RJ-48 Connector to RJ-48 Connector Pinouts for the 1-Port T1/E1 Mini-Physical Interface Module
(SRX-MP-1T1E1-R) | 51
RJ-48 Connector to DB-15 Connector Pinouts for the 1-Port T1/E1 Mini-Physical Interface Module
(SRX-MP-1T1E1-R) | 52
1-Port T1/E1 Mini-Physical Interface Module (SRX-MP-1T1E1-R) Basic Configuration | 54
RJ-48 Connector to RJ-48 Connector Pinouts for the 1-Port T1/E1 Mini-Physical Interface
Module (SRX-MP-1T1E1-R)
The 1-Port T1/E1 Mini-Physical Interface Module (Mini-PIM) uses an RJ-48 cable, which is not supplied
with the Mini-PIM.
CAUTION:
cable.
Table 29 on page 51 lists the RJ-48 connector to RJ-48 connector (straight) pinouts.
Table 29: RJ-48 Connector to RJ-48 Connector (Straight) Pinouts
RJ-48 Pin (on 1-Port T1/E1
Mini-PIM)
1
2
4
5
3
6
To maintain agency approvals, use only a properly constructed, shielded
RJ-48 Pin (Data Numbering
Form)
1
2
4
5
3
6
Signal
RX, Ring, –
RX, Tip, +
TX, Ring, –
TX, Tip, +
Shield/Return/Ground
Shield/Return/Ground
51