Messages; Close Cover (Front Cover/Cover L/Cover R/Front Uv Shield/Rear Uv Shield); Sheet Not Loaded Press Setup Key; End Of The Sheet - Roland VersaUV LEC2-300 User Manual

Messages

These are the main messages that appear on the machine's display to prompt correct operation. They do not indi-
cate any error. Follow the prompts and take action accordingly.
1 ■ 2 ■ 3 ■ 4 ■ 5■ 6 ■ 7 ■ 8 ■
Only a small amount of ink remains.
Replace the ink cartridge indicated by the flashing number with a new cartridge.

CLOSE COVER (FRONT COVER/COVER L/COVER R/FRONT UV SHIELD/REAR UV SHIELD)

The front, left, or right cover or the front or rear UV shield is open. For safety, some carriage operations are
limited while a cover is open.
Close the front, left, or right cover or the front or rear UV shield.

SHEET NOT LOADED PRESS SETUP KEY

This message appears when an attempt to perform a printing test was made while no media was loaded.
Load media.

END OF THE SHEET

The trailing edge of the media was detected during operation.
Press any key on the operation panel to clear the message. Load new media.

EMPTY DRAIN BOTTLE

This message appears when a certain amount of discharged fluid collects in the drain bottle.
Discard the discharged fluid in the bottle.
RELATED LINKS
・ P. 195 "If the Discharged Fluid Disposal Message Appears"

LIMIT OVER EMPTY DRAIN BOTTLE

This message appears when the drain bottle has reached its limit for discharged fluid.
When this message is displayed, immediately discard the discharged fluid.
RELATED LINKS
・ P. 196 "If the Drain Bottle Exceeds Its Capacity Limit"

INSTALL DRAIN BOTTLE

Check whether the drain bottle is installed correctly.
Install the drain bottle, and then press [ENTER].
RELATED LINKS
・ P. 194 "Disposing of Discharged Fluid"

TIME FOR FELT REPLACE

It is time to replace the felt wiper.
After verifying the message, press [ENTER], and then replace the felt wiper.
270
5. Messages on the Operation Panel