Step 2: Starting Output - Roland VersaUV LEC2-300 User Manual

Step 2: Starting Output

Never touch the print-head carriage while output is in progress.
CAUTION
The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause
injury.
Procedure
1.
Before the start of daily operations, remove just the white ink cartridge, shake it 50 times (about 20 seconds), and
then reinsert it.
So that the ink mixes well, shake the ink cartridge horizontally with a stroke length of around 5 cm (2 in.)
from each end of the ink cartridge.
IMPORTANT
The ingredients in white ink tend to settle. The precipitation of the ingredients in the ink disables printing in normal color. Al-
lowing the ink to stand without carrying out these steps can cause the settled material to harden, resulting in malfunction or
other problems.
2.
Close the front cover.
3.
Check that [SETUP] is lit.
If [SETUP] is not lit, the setup is not completed. Lower the loading lever, and then press the [ENTER] key.
4.
Check that the screen shown below (the top menu) is displayed.
If the top menu is not displayed, press [MENU].
W 736mm
5.
Send the output data from the computer.
For information on how to create the output data, refer to the documentation for the included software RIP.
MEMO
When you send the output data, "CLEANING" may be displayed on the screen. These indicate the preparation operations per-
formed before output. Output will begin after the time displayed on the screen elapses.
IMPORTANT
Output Is Not Possible in These Situations
• The machine does not run when a cover (front, left, right, or the UV shield [rear]) is open.
• Data from the computer is not accepted when [SETUP] is dark.
• Data from the computer is not accepted when you are not at the top menu.
Points that must be observed
Printing and Cutting Output
3. Printing and Cutting Method
93