Manual Cleaning Method - Roland VersaUV LEC2-300 User Manual

Manual Cleaning

Manual Cleaning Method

Be sure to perform manual cleaning after daily operations are finished. If you want to perform unmanned printing
at night, perform manual cleaning before sending the print data.
CAUTION
CAUTION
IMPORTANT
Important notes on this procedure
• Before attempting this operation, remove any media.
• To prevent the print heads from drying out, finish this procedure in 10 minutes or less. A warning beep sounds after 10 minutes.
• Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may damage the
print heads.
• Use only the included cleaning liquid.
• Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks will adversely affect the
printing results.
• Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the cleaning liquid.
• Never rub the print head surface (nozzle surface).
• Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
• If you use up the cleaning sticks or cleaning liquid, contact your authorized Roland DG Corporation dealer or visit our website
(
http://www.rolanddg.com/
If a warning beep sounds during cleaning
• A warning beep sounds 10 minutes after operation begins. Stop work, close all the covers, and then press [ENTER] to end the man-
ual cleaning mode. After that, restart the procedure from the beginning.
Cleaning sticks
1.
Clean the print heads.
Procedure
1.
Remove any media.
2.
Remove the media clamps.
3.
Press [FUNCTION].
4.
Press [▼], then [▶].
5.
Press [▼] several times to display the screen shown below.
CLEANING
MANUAL CL.
6.
Press [ENTER].
When the media clamp removal message is displayed, press [ENTER] again. After "NOW PROCESSING.." is
displayed, the screen shown below appears.
202
2. Regular Maintenance
Do not perform cleaning immediately after printing has finished. (Wait approximately 15
minutes after printing has finished.)
The area around the UV-LED device is hot and may cause burns.
Be sure to perform operations as specified by the instructions here, and never touch any
area not specified in the instructions.
Sudden movement of the machine may cause injury.
).
Required items
Cleaning liquid