Ricoh FT8982 Operating Instructions Manual page 123

While pressing the release lever
on the rear side guide, slide the
front and rear guides completely
away from each other. Then,
slide out the end plate com-
pletely.
Load paper in the tray.
Do not stack paper over the limit
mark.
The paper stack must be flush with
the left side fence.
Align the paper with the correspond-
ing size graduations on the bottom
plate.
While pressing the release levers
on the rear side guide, slide the
front and rear guides until they
securely hold the paper.
Slide the end plate until the paper
is flush with the paper tray fence.
Push the tray until it stops.
When closing the tray, push it gently.
After closing the tray, check the paper size display on the touch panel display.
If no paper size is indicated or paper size that you have set is not indicated,
press the Down key and pull out the tray. Set the front and rear guides and the
end plate flush with the paper, then close the tray.
CHANGING PAPER SIZE
115