Transport carriage
4.1.2 Setting the distance between switching screw and reference
Fig. 64: Setting the distance between switching screw and reference switch
(1) - Reference switch
(2) - Switching screw
Proper setting
When the transport carriage (3) is in its rear end position, the distance
between reference switch (1) and switching screw (2) must be 1 mm.
To set the distance between switching screw and reference switch:
1. Loosen the screw on the switching screw (2).
2. Set the height of the switching screw (2).
Set the distance between switching screw (2) and reference
3. Tighten the counternut.
4. Slide the transport carriage (3) all the way back.
5. Verify that the distance between reference switch (1) and screw (2)
Service Instructions 745-35-10 D - 00.0 - 10/2017
switch
①
②
switch (1) to 0.5 - 1 mm.
is 0.5 - 1 mm.
(3) - Transport carriage
③
75