Table of Contents
Advertisement
3. Insert the positioning device (6) into the mounting plate (1).
4. Align the mounting plate (1) parallel to the edge of the sliding plate (4).
5. Tighten the screw (7).
6. Loosen screws (2) and (3).
7. Align the left edge of the clamp (5) parallel to the edge of the sliding
8. Tighten screws (2) and (3).
13.2 Setting the pattern shift correction
Information
There will be a design-related pattern shift between the breast welt, as po-
sitioned exactly as per the pattern, and the turned breast welt. The pattern
shift is corrected by the stroke of the cylinder.
Fig. 114: Setting the pattern shift correction
(1) - Cylinder
To set the pattern shift correction:
1. Sew a test seam.
2. Fit out (turn) the breast welt pocket.
3. Check the matching of the pattern.
4. Loosen the screw (2).
5. Adjust the cylinder (1) in its holder.
6. Tighten the screw (2).
128
plate (4).
①
②
Positioning device
(2) - Screw
Service Instructions 745-35-10 D - 00.0 - 10/2017
Advertisement
Table of Contents
