Table of Contents
Advertisement
Transport clamps
Checking the transport clamp quick adjustment
To check the transport clamp quick adjustment:
1. Uncouple both locking plates (disengage pneumatically).
2. Place a white sheet of paper on the sliding plate.
3. Press the pedal forwards and move the transport clamps to the front.
4. Lower the folder.
5. Check the distance between transport clamp and folder.
5.4 Setting the front end position of the transport clamp
Fig. 77: Setting the front end position of the transport clamp
(1) - Reference switch
Proper setting
Dimensional check for the front edge of the transport clamp:
The front edge of the transport clamp must, therefore, be at a
Service Instructions 745-35-10 D - 00.0 - 10/2017
NOTICE
Property damage may occur!
The folder collides with the transport clamps while being lowered.
The transport clamp position must be adjusted to the appropriate
folder.
①
• Spacing A (front positioning point) + sewing length + 15 mm.
distance of 111+180+15 = 306 mm from the middle of the needle.
(2) - Rear stop
②
89
Advertisement
Table of Contents
