Needle Bar Linkage; Disassembling The Needle Bar Linkage - DURKOPP ADLER 745-35-10 D Service Instructions Manual

Hide thumbs Also See for 745-35-10 D:

Table of Contents

3.8 Needle bar linkage

Removing the head cover

Fig. 16: Removing the head cover

(1) - Screws

(2) - Head cover

To remove the head cover:

1. Unscrew the screws (1).

2. Carefully loosen the clamp for the needle thread monitor (3).

3. Remove the head cover (2).

Risk of injury from moving parts!

Crushing possible.

Switch off the machine before adjusting the

settings of the needle bar linkage.

Make sure not to damage the needle thread monitor when doing so.

(3) - Clamp for the needle thread monitor

Service Instructions 745-35-10 D - 00.0 - 10/2017

Machine head