H2: Multi-Function Digital Outputs - YASKAWA E1000 Technical Manual

5.7 H: Terminal Functions
Setting 90 to 97: DriveWorksEZ Digital Input 1 to 8
These settings are for digital inputs functions used in DriveWorksEZ. Normally there is no need to change these settings.
Setting 9F: DriveWorksEZ Disable
This function is used to enable or disable a DriveWorksEZ program in the drive. An input programmed for this function
is effective only if A1-07 = 2.
Status
Open
Closed

◆ H2: Multi-Function Digital Outputs

■
H2-01 to H2-03: Terminal M1-M2, M3-M4, and M5-M6 Function Selection
The drive has three multi-function output terminals.
H2-01, H2-02, and H2-03.
No.
H2-01
H2-02
H2-03
Setting
0 During Run
1 Zero Speed
2 Speed Agree 1
3 User-set Speed Agree 1
4 Frequency Detection 1
5 Frequency Detection 2
6 Drive Ready
7 DC Bus Undervoltage
8 During Baseblock (N.O.)
9 Frequency Reference Source
A Run Command Source
B Torque Detection 1 (N.O.)
C Frequency Reference Loss
E Fault
F Through Mode
10 Minor Fault
11 Fault Reset Command Active
12 Timer Output
13 Speed Agree 2
14 User-set Speed Agree 2
15 Frequency Detection 3
16 Frequency Detection 4
17 Torque Detection 1 (N.C.)
1A During Reverse
1B During Baseblock (N.C.)
Setting 0: During Run
Output closes when the drive is outputting a voltage.
Status
Open Drive is stopped.
Closed A Run command is input or the drive is during deceleration or during DC injection.
190
DriveWorksEZ enabled
DriveWorksEZ disabled
Parameter Name
Terminal M1-M2 Function Selection (relays)
Terminal M3-M4 Function Selection (relays)
Terminal M5-M6 Function Selection (relays)
Table 5.29 Multi-Function Digital Output Terminal Settings
Function Page
Description
Table 5.29 lists the functions available for theses terminals using
Setting
190 1E Restart Enabled
191 1F Motor Overload Alarm (oL1)
191 20 Drive Overheat Pre-alarm (oH)
192 2F Maintenance Period
191 37 During Frequency Output
192 38 Drive Enable
193 39 Watt Hour Pulse Output
193 3A Drive Overheat Alarm (oH2)
193 3B RUN Command from Option Card/Communications
193 3C LOCAL/REMOTE Status
193 3D During Speed Search
194 3E PI Feedback Low
194 3F PI Feedback High
194 4A During KEB Operation
194 4B During Short Circuit Braking
194 4C During Fast Stop
194 4D oH Pre-alarm Time Limit
194 50 Waiting for Run
194 58 Underload Detection
195 60 Internal Cooling Fan Alarm
195 90 Driveworksez Digital Output 1
195 91 Driveworksez Digital Output 2
194 92 Driveworksez Digital Output 3
196 100 to 192 Functions 0 to 92 with Inverse Output
196 –
Description
YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
Setting Range
0 to 192 0: During run
0 to 192 1: Zero Speed
0 to 192 2: Speed agree 1
Function
–
Default
Page
196
196
196
197
197
197
197
197
197
197
197
197
198
198
198
198
198
198
198
198
198
198
–