Verifying Parameter Changes: Verify Menu; Simplified Setup Using The Setup Group - YASKAWA E1000 Technical Manual

4.3 The Drive and Programming Modes

◆ Verifying Parameter Changes: Verify Menu

The Verify Menu lists edited parameters from the Programming Mode or as a result of Auto-Tuning. It helps determine
which settings have been changed, and is particularly useful when replacing a drive. If no settings have been changed, the
Verify Menu will read
that have been changed.
Note: The Verify Menu will not display parameters from the A1 group (except for A1-02) even if those parameters have been changed
from their default settings.
The following example is a continuation of the steps above. Here, parameter C1-02 is accessed using the Verify Menu,
and is changed again from 30.0 s to 20.0 s.
To check the list of edited parameters:
1. Turn on the power to the drive. The initial display appears.
2.
Press or
Press to enter the list of parameters that have been edited from their original default settings.
3.
If parameters other than C1-02 have been changed, use the
4.
Press the key to access the setting value. Left digit flashes.

◆ Simplified Setup Using the Setup Group

In the Setup Group, the drive lists the basic parameters needed to set up the drive for the application. It provides a
simplified way to get the application running right away by showing only the most important parameters.
■
Using the Setup Group
Figure 4.6 illustrates how to enter and how to change parameters in the Setup Group.
The first display shown when entering the Setup Group is the Application Selection menu. Skipping this display will
keep the current Setup Group parameter selection. The default setting for the Setup Group is a group of parameters most
commonly use in general-purpose applications. Pressing the ENTER key from the Application Selection display and
selecting an Application Preset will change the Setup Group to parameters optimal for the application selected.
Application Selection on page
In this example, the Setup Group is accessed to change b1-01 from 1 to 0. This changes the source of the frequency
reference from the control circuit terminals to the digital operator.
104
. The Verify Menu also allows users to quickly access and re-edit any parameters settings
Step
until the display shows the top of the Verify Menu.
111.
or key to scroll until C1-02 appears.
YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
Display/Result
ALM
DIGITAL OPERATOR JVOP-182
DRV
REV DRV FOUT
Refer to