Mounting The Stator With Cooling Jacket - Siemens Simotics M-1FE1 Series Hardware Installation Manual

Mechanical mounting
5.4 Mounting the stator with the spindle housing
6. Insert the O-ring seals in the slots.
7. Screw the eyebolts, if necessary with spacer sleeves, into the front face of the cooling
jacket for the attachment of the hoisting gear.
You have made preparations for mounting.
5.4.3

Mounting the stator with cooling jacket

There are several variants for joining the stator with the spindle housing.
Note
The spindle manufacturer is responsible for selecting and executing the joining process.
NOTICE
Damage to power and sensor cables
The power and sensor cables can be damaged during mounting.
• Position the cables so they are not damaged during mounting.
• Avoid tensions on the cables.
• Do not crush the cables.
Note
The spindle housing seals the cooling thread of the cooling jacket from the exterior.
76
1FE1 synchronous built-in motors
Hardware Installation Manual, 12/2016, 610.43000.40b