Table of Contents
Advertisement
10.3
Disposal
10.3.1
Disposal - Introduction
The product must be disposed of in the normal recycling process in compliance with national
and local regulations.
10.3.2
Guidelines for disposal
Injury or material damage if not correctly disposed of
If you do not correctly dispose of direct drives or their components (especially components
with permanent magnets), then this can result in death, severe injury and/or material
damage.
• Ensure that direct drives and their associated components are correctly disposed of.
Main constituents of a proper disposal procedure
● Complete demagnetization of the components that contain permanent magnets
● Components that are to be recycled should be separated into:
– Electronics scrap (e.g. encoder electronics, Sensor Modules)
– Electrical scrap (e.g. motor windings, cables)
– Scrap iron (e.g. laminated cores)
– Aluminum
– Insulating materials
● No mixing with solvents, cold cleaning agents, or residue of paint, for example
1FE1 synchronous built-in motors
Hardware Installation Manual, 12/2016, 610.43000.40b
WARNING
Decommissioning and disposal
10.3 Disposal
141
Advertisement
Table of Contents
