Mounting The Stator With The Spindle Housing; Production Equipment, Assembly Tools And Other Resources - Siemens Simotics M-1FE1 Series Hardware Installation Manual

5.4

Mounting the stator with the spindle housing

5.4.1

Production equipment, assembly tools and other resources

Ensure the ambient conditions from Chapter Mounting instructions (Page 55).
Provide the following production equipment, assembly tools and other resources:
1
2
3
4
5
6
● Occupational safety equipment:
– Face protection shield
– Protective gloves
– Closed protective clothing for protection against high surface temperatures
● Hoisting gear with suitable load suspension device for the stator core
● Eyebolts or ring nuts and spacing sleeves
● Axial stop for cooling jacket/stator core without cooling jacket
● Internal tensioning spindle for the laminated stator core
● Plastic-covered support arm (for horizontal mounting)
● Anti-corrosion agent for steel surfaces
● Grease or talcum as lubricants for Viton O-ring seals
For the leak test with liquid:
● Water connection, maximum test pressure 0.7 MPa (7 bar).
1FE1 synchronous built-in motors
Hardware Installation Manual, 12/2016, 610.43000.40b
Appropriate axial stops (examples)
Lifting accessories (examples)
Eyebolts
Spacing sleeves
Plastic-covered support arm for horizontal mounting (example)
Internal tensioning spindle (example)
5.4 Mounting the stator with the spindle housing
Mechanical mounting
73