Table of Contents
Advertisement
Mechanical mounting
5.6 Installation
5.6
Installation
5.6.1
Placement of the motor spindle
NOTICE
Danger of component destruction caused by contact with hot surfaces
If temperature-sensitive components and cables come into contact with hot motor surfaces,
they can be damaged or destroyed.
• Install temperature-sensitive components and cables so they cannot come into contact
● Observe the project specifications of the spindle manufacturer.
● Observe the technical data on the motor housing rating plate or the details contained in
the machine documentation of the spindle manufacturer.
● Check whether the rating plate details match the conditions pertaining at the installation
location.
● Observe the permitted maximum radial and axial vibration values.
● Ensure that the motor spindle mounting (e.g. foot-flange or mounting foot) has even
contact with the mounting surface. Stresses of the motor spindle are not permitted.
● Turn the output elements by hand.
If a grinding noise occurs, rectify the cause or contact the manufacturer.
Emissions
The motors are certified for a wide range of mounting and operating conditions.
The installation and operating conditions can affect the motor noise.
5.6.2
Permissible motor vibrations
The following effects can increase motor vibration values:
● The on-site system vibration characteristics depend on factors such as the output
elements, mounting conditions, alignment and installation.
● Effects of external vibration
Ensure that the vibration values conform to project specifications and the following tables are
not exceeded at the specified measuring points on the motor.
Observe the notes for measuring points, measurement and evaluation according to ISO
10816.
92
with the hot motor surface.
1FE1 synchronous built-in motors
Hardware Installation Manual, 12/2016, 610.43000.40b
Advertisement
Table of Contents
