Juniper MX2020 Hardware Manual page 277

CAUTION:
prepared to accept the full weight—up to 15 lb (6.8 kg)—as you slide the CB-RE
out of the chassis.
When the CB-RE is out of the chassis, do not hold it by the ejector handles, bus
bars, or edge connectors. They cannot support its weight.
CAUTION:
each component on an antistatic mat resting on a stable, flat surface.
Figure 98: Removing a CB-RE
0
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX2020 Router
Overview of Preparing the Site for the MX2020 Router | 121
The weight of the CB-RE is concentrated in the back end. Be
Do not stack CB-REs on one another after you remove them. Place
19
257