Juniper MX204 Hardware Manual page 115

3. Label the cables connected to the transceiver so that you can reconnect them correctly later.
4. Remove the cable connector from the transceiver. Immediately cover the transceiver and the end of
the cable with a rubber safety cap.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to a
transceiver emit laser light that can damage your eyes.
5. Pull the ejector handle out from the transceiver to unlock the transceiver.
CAUTION:
click. Doing this prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
6. Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3 cm) out of the
interface port.
7. Using your fingers, grasp the body of the transceiver, and pull it the rest of the way out of the interface
port.
8. Place a rubber safety cap over the transceiver.
9. Place the removed transceiver on an antistatic mat or in an electrostatic bag.
CAUTION:
reinserting it or inserting a transceiver into a different slot.
Do not look directly into a fiber-optic transceiver or into the ends of
Make sure that you open the ejector handle completely until you hear it
After removing a transceiver from the chassis, wait at least 30 seconds before
118